Pick up the first of the 2 inch twisted piece of wire and with three step barrel nose pliers, and using the largest barrel curl the first end inward. Turn and curl the other end in the opposite direction. Finish the other 2 the exact same way.

With the first long already curled ends mark the center, With a 2 foot section of 21 gauge half round wire, start wrapping from the center wrap 6 times. Mark the end of the first six wraps, turn and wrap 6 times in the opposite direction to total 15 wraps. The mark on the end of the first six is to keep you on center. Place the first infinity wrap each circle of the infinity three times on each one. Now wrap the bar 10 times on both sides. Now attach the next infinity piece with 3 wraps, wrap 15 times between the next ends of the infinity and wrap it 3 times. Turn and repeat with the third infinity.

*Splicing the half round wire sections, do this in on just the bar section never in the infinity circle itself. Leave off in a convenient place on the bar to start the next 21 gauge 2 foot section. Leave a small tail and start next piece also leaving a small tail. We will trim these later and bury inside later, leave the tails pointing towards the inside of the piece.

Finish wrapping the bar with the 21 gauge half round until you reach the point where you wrap the other bar on at the curl three times before you continue to wrap around the curl at the end of the first bar. Continue wrapping where the 2 curls meet wrap 3 times around both curls and then twice around the newly attached bar trim wire and bury.