Glue the face (11mm pearl) to the halo (15mm earring dangle).

Using round nose pliers, make an open spiral at the end of each of the four 20-gauge wires, making sure the open spirals are different sizes.
Line up the straight ends of the 4 wires, so that the ends are parallel. Make a bundle at this end, using half-round wire to wrap 4 or 5 times to show. Trim the 4 wires to be nearly flush with the wrap wire.

Attach the 3 jump rings to the open spirals for stability. You've completed the angel's skirt.

Glue the angel's skirt to the front of your wings with E6000 glue. Wait at least 1-1/2 hours for the glue to dry before going on to the next step.

Glue the halo-face combination to the front of the wings, just above the skirt. Allow glue to dry.

Glue the bow to the bundle wrap wire for a finished look. Allow glue to dry.

Glue the flat part of the tie tac to the back of the wings, in the center. Let the glue dry.

Wear and enjoy!