Measure and cut 2 pieces of round 16 gauge copper wire at 1 ½ inches, 2 pieces of round copper wire 16 gauge at 2 ½ inches, 3 pieces of round copper wire 18 gauge at 3 inches, 10 pieces of half round copper wire 21 gauge at 1 inch and finally, 1 piece of round 24 gauge wire 2 inches long. That's for one earring.

Using your round nose pliers, make a loop at one end of one of your 2 ½ inch pieces of 16 gauge wire by grabbing the end of the wire and rolling it in until it touches itself.

Holding on to the uncoiled end, keep your pliers in the loop and roll it over until it resembles a candy cane. (You will adjust the size later when you make the second scroll.)

Make a loop on the opposite end of your wire and coil it the opposite way from your first making it look like an S shape.

Repeat steps 2, 3, and 4 with your second piece of 2 ½ inch 16 gauge wire. Lay the two pieces on top of each other and adjust shape to get them the same size.

Take 1 piece of your 1 ½ inch 16 gauge wire and put a loop on both ends rolling them toward each other until they touch in the middle. Do this with the other three 1 ½ pieces.

Using your hammer and steel block, hammer all 6 of your scrolled pieces until they are evenly level when placed on a flat surface beside each other

With your round nose pliers, bend all of your ½ round 21 gauge pieces of wire in the middle into a V shape, making sure to keep the round side on top and the flat side of the wire underneath.

Place the 2 large scrolls next to each other, facing opposite and touching as shown. Now place one of your ½ round bent pieces around both scrolled pieces at the bottom. Wrap the ½ round piece twice ending up on the same side and clip off excess with your cutters. Take your chain nose pliers and give the wrapped area a squeeze to make it secure. (When cutting ends of wire, make sure they are all cut on the same side or back of earring.)

Bend your piece of 24 gauge wire in the center with your round nose pliers.

Measure ¼ of an inch on both sides from the center bend and bend the wire as shown.

On your round nose pliers, put an open loop at the top bend on both sides.

Place your 24 gauge piece of wire on a flat surface, hold the loops down with your finger and point the end of the wire on each side upward. Slip the earring body onto the 24 gauge piece of wire and press wire with your fingers to the sides.

Grab the end of your wire with your chain nose pliers and wrap both sides of your wire around three times, cut off excess and use your pliers to smooth any sharp ends.

Take your three pieces of 18 gauge 1 inch wire and flatten one end on your steel block with your hammer to make a paddle.

Slide on your 4mm crystal and then your 6mm crystal to all three paddles.

Grab the end of the wire and roll it towards the crystals to make a loop at the top.

To finish, add the crystal charms with jump rings so they dangle freely, one on each side of the earring. To connect the bottom drop I added three jump rings. A jump ring through each earring loop and then one through both jump rings with the drop added. Put your ear wire on and then repeat all steps for the second earring. (Always remember to open jump rings side to side and close them the same way.)