Using your flat nose pliers, bend down toward the inside, the two outside and two inside twisted wires on each side. Mark 2/8" and cut the wire. Using the tip of your round nose pliers, slightly bend each tip of the wire toward the backside of the bracelet. Bend them down untill they touch the back of the bracelet. With the two untwisted wires, cut them both to 1/2". Using your flat nose pliers, bend the wires up towards the front of the bracelet. Then, with your round nose pliers, bend the wires towards the back of the bracelet to form an open loop. Do this on both ends of the bracelet.