Home / Jewelry Making Tips and Techniques / How to Set Stones into Earring Snapsets
How to Set Stones into Earring Snapsets
by Dale Armstrong
Question:

How do you use the earring snapsets? I purchased the 6mm earring snapset with the 6mm stones to go in them, and I realized I don't know how to use them with the earring post in the center - can someone give me directions?

-Barb in Puyallup, Washington
Instructions
Answer:

The easiest way to set stones into earring snapsets is to:

1. Place the stone, table side down, on a roll of tape* (sticky side out).
2. Holding the setting between your fingers, center the setting over the stone.
3. Push the setting onto the stone. You should hear a definite snap.
Dale Armstrong's How to Set Stones into Earring Snapsets - , Findings & Components, Toggles & Clasps, Earwire & Headpin, Findings, Clasps, Components, , Using earring snapset
Dale Armstrong's How to Set Stones into Earring Snapsets - , Findings & Components, Toggles & Clasps, Earwire & Headpin, Findings, Clasps, Components, , Using earring snapset
If the stone goes to one side and the prongs end up bent, use needle nose or chain pliers to adjust and reposition the prongs, and then try again.

* - Take a piece of tape and stick the ends together, making sure the sticky side is out.

Answer contributed by Dale "Cougar" Armstrong

Materials

Snapsets found in findings by metal type
Shop Now
Cubic Zirconia stones
Shop Now
Add All Items to Cart

Tools

Scotch 3/4 Inch Painters Tape for Taping Wires Together
G13-5
  • G13-5
  • Lesson Quantity: 1.00 pieces
  • Purchase Quantity: 1.00 each
  • Price: $5.97
  • Gold Club Price: $4.48
Out of Stock
Add All Items to Cart
  • Category: Findings
  • Technique(s): Making Findings, General Education

Reviews

Login to post a Review
Login to be the first to review this Tip!